Deco Color-Plastic Primer Clear 400ml
Have difficulties in applying paint to plastic surface?
Your paint drips? We got solution!
Coating adhesion increasing primer for such plastic surfaces as PUR, PS, PA, EPDM, ABS, GfK, Hart – PCV etc. Possibility of direct application under top layer (enamel/lacquer). Possibility of direct application under primed layer (primers) If you want to use primer previously, apply Plastic Primer first, use Anti-corrosive Primer / Acryl Primer 1K as a second layer, then e.g. Decoration at the end, as final layer.
Best result when applied at 10-25°C.
Short drying time: up to 5 min
Efficiency 6 m² by one application
Compatible with all paint systems (alkyd, acrylic, nitro-combination) water and solvent based
For indoor and outdoor use
Capacity 400 ml
Before applying read carefully instructions on the container and use according to the manufacturer’s recommendations.
Recommended substrate conditions:
Preparing the substrate is very important action influencing the quality and life of varnish coating. Fundamental principle, which relate to all surfaces prepared to painting is to grind, degrease and dry out. After drying the primed surface should be grinded with fine-grained sandpaper (e.g. P600).
How to use:
Apply product at temperature about 10-25°C (optimum temperature for good varnish drying). Drying time depends also on air humidity and product density. Painting should be made in well ventilated room. Prior to commencing painting, shake the container for about one minute, which will help mix the varnish by the ball found inside. Perform the test spray. Apply the varnish with few thin layers rather than one thick layer, from the distance of 25-30 centimetres. Following applying each layer, wait a few minutes. Following the completion, clean the nozzle. Put the container upside down, pressing the nozzle for the period of three seconds.