Brand: Deco-Color
Product Code: Deco Color-New Bath Swiss Formula 2K Enamel
Availability: In Stock
22.76€ 25.83€
Ex Tax: 18.50€

Deco Color-NewBath Swiss Formula 2K Enamel 

Professional 2K enamel for cast iron, enamel and acrylic bathtubs renovation. Suitable for painting toilets, sinks, showers etc. Suitable also for other surfaces such as ceramics, wood, laminate surfaces (boats, yachts, airplanes), steel and aluminium as well as for plastic elements. Designed to coat surfaces above and below the waterline.


Notice:

Professional two-component product recommended by companies which are specialized in baths renovations.

Short drying time: 16 h – hardened

Standard colour RAL 9016 pure white

Super gloss and long lasting colour, does not become yellow, high resistance to UV

Next layer application: minimum 60 min, maximum 18-24 h

Perfectly covers and fills, creating diamond coating

Efficiency: 7 m², enough for bath and washbasin

Weather conditions and salt water resistance

Good filling properties

High temperature resistance up to 80°C

For indoor and outdoor use

Capacity 500ml


Main features:


Short time of full hardening: only 16 hours

High capacity: one container is sufficient for bath-tube and wash-basin

Good covering power

Perfectly fills fine capillary base pits

High resistance for UV radiation (does not subject to yellowing)

Creates durable and high-gloss coating

Resistance to weather conditions, fresh and salt water 


Physical and chemical properties:


Capacity 500 ml (enamel + curing agent)

Base/resin acryl-polyurethane

Colour RAL 9016 pure white

Gloss  full gloss

Application temperature circa 20°C (minimum 10°C)

Dust free  50 minutes  

Touch free  after 90 minutes

Completely dry   after 12-16 hours

High temperature resistance: till 80°C

VOC content 550g/ml                                    

        

Usage:

Before applying read carefully instructions on the container and use according to the manufacturer’s recommendations.


Recommended substrate conditions:


Preparing the substrate is very important action influencing the quality and life of varnish coating. Fundamental principle, which relate to all surfaces prepared to painting is to grind, de-grease and dry out. After drying the primed surface should be grinded with fine-grained sandpaper (e.g. P600). If the consecutive layers are applied within 24 hours there is no need to grind between them. When used in capacity of renovation coating, the enamel can be applied directly on coatings showing good adhering properties, based on two-component paints (polyurethane or epoxy), or directly on thoroughly degreased raw surfaces. 


How to use:

The enamel can be applied with spray gun, brush or roller. At the best apply the enamel at temperature about 10-25°C (optimum temperature for good varnish drying). Drying time de-pends also on air humidity and product density. Painting should be made in well ventilated room. Before painting thoroughly mix A and B components. Protect surfaces not intended for painting, then start spreading the enamel. After being mixed, the preparation is ready to use for 4-6 hours at 20°C.

Write a review

Please login or register to review